! ! MakeKermit: Command file to compile and load Kermit. ! ! To install Kermit-Perq, you will have to: ! 1) In KermitScreen: Change the constant KermitFont to the name of ! the font file you wish to use in the terminal window. ! 2) In KermitMain: Change the constants MSegFile and HLPFile so the ! pathnames of Kermit.MSEG and Kermit.HLP in KermitMain ! refer to the directories in which these files are located. ! 3) Copy the Kermit-commands .CMD-files into a suitable directory ! ( e.g. :boot ) ! 4) Read the comments below to decide whether this command file will ! have to be modified before running it. ! ! Assume sys:boot> will always be in the searchlist! ! ! The three first commands will only be required if IOUtils, UtilDefs and ! MenuUtils is to be installed with Kermit. Otherwise they will have to ! be reachable in the same way as the system modules. ! com/norange/error IOUtils.Pas com/norange/error UtilDefs.Pas com/norange/error MenuUtils.Pas ! com/norange/error KermitConnect.Pas com/norange/error KermitFile.Pas com/norange/error KermitGlobals.Pas com/norange/error KermitLineIO.Pas com/norange/error KermitMain.Pas com/norange/error KermitParameters.Pas com/norange/error KermitRead.Pas com/norange/error KermitScreen.Pas com/norange/error KermitSend.Pas ! ! Change output file spec. if Kermit.RUN should be located in any other ! directory than sys:boot> ! link KermitMain ~sys:boot>Kermit